Upgrading of illumination system at Vilnius Railway Station
Fluorescent and incandescent bulbs have been used in the illumination system of the Vilnius railway system until the present time. Upgrading of illumination with LED lighting fixtures covered the corridor of the railway station, an underground passage, exits leading to platforms, left-luggage office, and information display boards. General effect of the project: electricity costs reduced by more than fourfold; reduced operating (maintenance) costs and enhanced lightness.
Vilnius railway station corridor (Pictures 1 and 2)
Instead of the previous 18W lighting fixtures, 2.5W LUMO SPOT1 bulbs with intensity control function were mounted. Half of the bulbs shine at 100% intensity, the other half – at 20% intensity. It may be programmed, however, that all lighting fixtures shined at 100% intensity during the necessary time of the day. After upgrading the illumination system, better lightness in this part of the station was obtained and nine-fold electricity savings have been achieved by maintaining the lighting standards of the corridor even when the lighting fixtures operate in standby mode.
In addition, latent lighting was installed in the corridors – LED modules were mounted instead of 36W luminescent bulbs what enabled to cut the power costs by more than threefold.
.jpg)
.jpg)
|
Picture 1. Railway station corridor. The central line of LED bulbs shine at 100% intensity, and the side ones – at 20% intensity. |
Picture 2. Latent LED illumination was upgraded in the railway station corridor. |
Underground tunnel of the Vilnius railway station (Picture 3)
The previously used 54W fluorescent bulbs were replaced with LUMO Line 8lighting fixtures that consume only 18W of electricity. An economic effect was achieved – threefold cut down on energy costs. Besides, the intensity of lighting was enhanced. An additional economic benefit is gained by reducing the intensity of lightness at a particular time of the day when there are no people in the premises.
.jpg)
.jpg)
Picture 3. The left picture shows a platform passage with a turned-off group of LED lighting fixtures, and in the right picture – with all fixtures operating at 100% intensity.
Information display boards at Vilnius railway station platforms (Picture 4)
.jpg)
18W fluorescent information display boards were replaced with two 2.5W LUMO SPOT1 bulbs. The lightness of display boards remained the same, whereas the energy costs decreased by approximately three times.
Picture 4. Upgraded information display board in the platform exit.
Left-luggage office at Vilnius railway station (Picture 5)
Instead of 72W fluorescent lighting fixtures, 36W LUMO60 LED lighting fixtures were mounted in the left-luggage office. The amount of energy consumed reduced twice; besides, the level of lighting was increased up to 110-150 Lux. When there are no people in the premises, movement sensors enable to cut down the level of intensity up to 20%, as a result whereof energy efficiency increased by even 10 times.
Fixtures in the passage leading to the left-luggage office were replaced using the very same principle.
.jpg)
.jpg)
Picture 5. Left-luggage office. In the left picture fixtures operate at 20% intensity, and in the right one – at 100% intensity.
Exits to platforms at Vilnius railway station (Picture 6)
Instead of 58W fluorescent bulbs, 18W LUMO Line 8 LED fixtures were mounted. This replacement alone enabled to achieve a significant electricity savings of 3.2 times. After installing a lighting control system that dims the light output up to 20% when there are no people in the exit, obtained electricity savings may even equal to 15 times. Moreover, bigger intensity of lightness was achieved than in previously used illumination system.
.jpg)
.jpg)
Picture 6. Upgrading of illumination in exits to the platform. In the left picture lighting fixtures operate at 20% intensity, and in the right one – at 100% intensity.
We recommend
-
LUMO SPOT 1
LED spot lighting deviceEfficacy, lm/W: 120
Luminous flux, lm*: 230
Power, W**: 2,3
External power converter is used.
-
LUMO SPOT 2
LED spot lighting deviceEfficacy, lm/W: 120
Luminous flux, lm*: 460
Power, W**: 4,7
External power converter is used.
-
LUMO SPOT 3
LED spot lighting deviceEfficacy, lm/W: 120
Luminous flux, lm*: 690
Power, W**: 7
External power converter is used.
-
LUMO LINE 4
LED linear lightingEfficacy, lm/W: 120
Luminous flux, lm*: 920
Power, W**: 9
Operating voltage, V: 36
-
LUMO LINE 8
LED linear lightingEfficacy, lm/W: 120
Luminous flux, lm*: 1840
Power, W**: 18
Operating voltage, V: 36
-
-
-
LUMO FL8
LED floodlightEfficacy, lm/W: 120
Luminous flux, lm*: 1840
Power, W**: 20
Standard single-phase connection input is used.
-
LUMO FL 6
LED floodlight -
LUMO INGA 20
LED suspended ceiling lightingEfficacy, lm/W: 120
Luminous flux, lm*: 4600
Power, W**: 44
-
LUMO INGA 16
LUMO suspended ceiling lightingEfficacy, lm/W: 120
Luminous flux, lm*: 3680
Power, W**: 34
-
LUMO INGA 12 ECO
LED suspended ceiling lightingEfficacy, lm/W: 120
Luminous flux, lm*: 2760
Power, W**: 30
-
-
-
-
-
-
-
LUMO INDUSTRY 48
LED pendant lightingLuminous flux, lm*: 11040
Power, W**: 99
Illumination angle, °: 45-170
-
-
-
-
-
-
-
-
-
-
-
